How to play
On the pottery wheel, shape the task piece (a Sake Bottle, Jar, Bud Vase, Vase, Trumpet Vase, Big Bowl or Gourd) along the dotted line, then fire it in the kiln. There's no time limit. The steps are the same as on a real wheel, and the band at the top shows the current step. First, Center: swipe up on the clay to raise it, then swipe down to press it back down (↑ and ↓ on a keyboard).
Next, Open: press down in the middle to open a hole (↓ on a keyboard). The bottom stays, and the clay opens into a tube.
Finally, Pull up: swipe up to make it taller, swipe down to make it shorter, and swipe sideways to swell or squeeze the body and rim. The tip below and the ▶◀ marks show where your biggest gap from the line is and which way to fix it. The screen also shows your match % with the dotted line, and a “Collapses here” line marking the height at which it will collapse if you keep pulling. When the shape is done, press “To kiln”. The “Model” button shows the finished shape again.
The amount of clay is fixed, so the more you stretch or swell it, the thinner the walls get and the more the pot wobbles. Overdo it and it collapses. Out of the kiln, the model's dotted line is laid over your piece and you get a match %. 80% or more is a success. If it's off, the kiln turns it into something else depending on your biggest gap.
Tips
- While pulling up, the tip below tells you the move that fixes your biggest gap. If you're not sure, swipe the way its arrows point.
- Make it taller last. Bring the neck and body to the dotted line first, and you can make it tall without it collapsing. When the “Collapses here” line appears, stop just short of it.
- Pull it past the height of the dotted line and it gets thin, then collapses or melts in the kiln. If it's too tall, swipe from top to bottom to shrink it.
Comments
Write a comment
No comments yet.